(
Jump to the original submission)
Tue 19 Nov 2002 02:02:10 PM UTC, comment #8:
The new release 0.4.1 reads the AC line state from /proc/apm. Should work now.
|
Mon 18 Nov 2002 10:54:20 PM UTC, comment #7:
Likewise on T30
|
Wed 13 Nov 2002 05:22:06 PM UTC, comment #6:
Yup, that seems to be the case. I had initially swapped the logic in the source to correct the problem, but now when I boot without AC it reports incorrectly.
|
Mon 11 Nov 2002 04:14:55 PM UTC, comment #5:
OK. If you boot WITHOUT AC connected it is NOT reversed, if you boot WITH AC connected it IS reversed. Can you please verify this.
The bad news are, that up to now I have not found a way to detect how it was powerd up :(
|
Mon 11 Nov 2002 08:55:34 AM UTC, comment #4:
Hmm. Most of the time mine is not reversed, but I have seen reversed display since I did intensive testing. I'll look into that.
|
Fri 08 Nov 2002 04:13:07 PM UTC, comment #3:
Still seeing it on a T20 with version 4.0
|
Wed 25 Sep 2002 12:19:20 PM UTC, comment #2:
Fixed in release 0.3.1
|
Wed 25 Sep 2002 12:13:50 PM UTC, comment #1:
Fixed in release 0.3.1
|
Fri 20 Sep 2002 12:11:42 AM UTC, original submission:
On my TP A30, AC-detection gets reversed, so when I pull my AC-cord, it says 'AC connected'.
|
(Note: upload size limit is set to 16384 kB, after insertion of the required
escape characters.)
Attach File(s):
Comment:
No files currently attached
Depends on the following items: None found
Items that depend on this one: None found
Follow 7 latest changes.