Tue 03 Dec 2013 06:29:23 PM UTC, original submission:
Here is the output of the MinGW windows binary build 6.0.1 dated 11/29/2013.
Note that the Fuse report at the end of the report indicates the high fuse value (H) in the extended fuse (E) position and visa-versa. The low fuse value (L) is correct as are the individual fuse reports.
I think I remember this being a n issue in an earlier version of avrdude if my memory serves me right.
C:avrdude>avrdude -c pickit2 -p t2313 -v
avrdude: Version 6.0.1, compiled on Sep 18 2013 at 08:20:41
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
Copyright (c) 2007-2009 Joerg Wunsch
System wide configuration file is "C:avrdudeavrdude.conf"
Using Port : usb
Using Programmer : pickit2
Device 0230DCB8 seemed to open OK.
AVR Part : ATtiny2313
Chip Erase delay : 9000 us
PAGEL : PD4
BS2 : PD6
RESET disposition : possible i/o
RETRY pulse : SCK
serial program mode : yes
parallel program mode : yes
Timeout : 200
StabDelay : 100
CmdexeDelay : 25
SyncLoops : 32
ByteDelay : 0
PollIndex : 3
PollValue : 0x53
Memory Detail :
Block Poll Page Polled
Memory Type Mode Delay Size Indx Paged Size Size #Pages MinW MaxW ReadBack
----------- ---- ----- ----- ---- ------ ------ ---- ------ ----- ----- ---------
eeprom 65 6 4 0 no 128 4 0 4000 4500 0xff 0xff
flash 65 6 32 0 yes 2048 32 64 4500 4500 0xff 0xff
signature 0 0 0 0 no 3 0 0 0 0 0x00 0x00
lock 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00
lfuse 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00
hfuse 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00
efuse 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00
calibration 0 0 0 0 no 2 0 0 0 0 0x00 0x00
Programmer Type : pickit2
Description : MicroChip's PICkit2 Programmer
avrdude: MicroChip's PICkit2 Programmer firmware version 2.32.0
program_enable(): sending command. Resp = 0 0 53 0
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.02s
avrdude: Device signature = 0x1e910a
avrdude: safemode: lfuse reads as A4
avrdude: safemode: hfuse reads as DF
avrdude: safemode: efuse reads as FF
avrdude: safemode: lfuse reads as A4
avrdude: safemode: hfuse reads as DF
avrdude: safemode: efuse reads as FF
avrdude: safemode: Fuses OK (H:FF, E:DF, L:A4)
avrdude done. Thank you.
|