patchAVR In-System Programmer - Patches: patch #3819, Implement reading 4 calibration...

 
 

You are not allowed to post comments on this tracker with your current authentication level.

patch #3819: Implement reading 4 calibration bytes for ATtiny26.

Submitter:  Anatoly Sokolov <aesok>
Submitted:  Thu 10 Mar 2005 11:42:12 AM UTC
   
 
Category:  None Priority:  5 - Normal
Status:  None Privacy:  Public
Assigned to:  None Open/Closed:  Open

Sun 13 Mar 2005 01:05:41 PM UTC, comment #1: 

Looks good with an STK500 under OSX 10.3.5:

  jfiresto% ./uisp -v -dserial=/dev/tty.modem -dpart=attiny26 -dprog=stk500 --rd_cal=4
  Firmware Version: 1.10
  Atmel AVR ATtiny26 is found.
  Firmware Version: 1.10
  Calibration Byte  0 = 0x96
  Calibration Byte  1 = 0x97
  Calibration Byte  2 = 0x8d
  Calibration Byte  3 = 0x91

Thanks!

John Firestone

Anonymous
Thu 10 Mar 2005 11:42:12 AM UTC, original submission:  

Implement reading up to 4 calibration bytes for ATtiny26 as request in support item # 103567. It was testeg using Altera ByteBlasterMV Parallel Port Download Cable. Should working with other hardware also.

Anatoly Sokolov <aesok>

 

(Note: upload size limit is set to 16384 kB, after insertion of the required escape characters.)

Attached Files
file #8550:  patch.diff added by aesok (6KiB - application/octet-stream)

 

Depends on the following items: None found

Items that depend on this one: None found

 

CC list is empty

 

There are 0 votes so far. Votes easily highlight which items people would like to see resolved in priority, independently of the priority of the item set by tracker managers.

 

Follows 1 latest change.

Date Changed by Updated Field Previous Value => Replaced by
2005-03-10 aesok Attached File- Added patch.diff, #4321

Back to the top

Powered by Savane 3.13-f8d8.
Corresponding source code