bugConstruo - Bugs: bug #4571, Drag&Drop slower than expected


bug #4571: Drag&Drop slower than expected

Submitter:  Ingo Ruhnke <grumbel>
Submitted:  Fri 01 Aug 2003 01:26:26 PM UTC
Category:  X11 Display Engine Severity:  3 - Normal
Item Group:  Incorrect Behaviour Status:  None
Privacy:  Public Assigned to:  None
Open/Closed:  Open Release:  0.2.2
Planned Release:  None
* Mandatory Fields

Add a New Comment Rich Markup

Fri 01 Aug 2003 01:26:26 PM UTC, original submission:  

Still not 100% sure what you mean, but here is what I could reproduce, if I create a huge model (5000 particles, 10000 springs) the drawing itself is still at around 12fps, insertion of new particle is also fine, zoom is also ok, but what is causing problem is drag&drop with both the collider and the selection tool. The collider tool takes a second or so before the drag starts, the drag itself is ok, but the gab until it starts is to long. Similar with the select tool, creating the selection itself is still perfectly responsible, but drag&droping the selection, gets done at a rate much lower than the fps and especially the start of the drag takes quite a few seconds. Anyway, this isn't a problem under my setup, since the simulation run itself gets already down to 1fps with that huge models, making these huge models simply unusable, couldn't reproduce anything like that with models that still 'run' at a useable speed.

Ingo Ruhnke <grumbel>
Group administrator


(Note: upload size limit is set to 16384 kB, after insertion of the required escape characters.)

Attach Files:

No files currently attached


Depends on the following items: None found

Items that depend on this one: None found


CC list is empty


There are 0 votes so far. Votes easily highlight which items people would like to see resolved in priority, independently of the priority of the item set by tracker managers.

Only logged-in users can vote.


No changes have been made to this item

Back to the top

Powered by Savane 3.13-758e.
Corresponding source code