AVR In-System Programmer - Patches: patch #3819, Implement reading 4 calibration...
You are not allowed to post comments on this tracker with your current authentication level.
patch #3819: Implement reading 4 calibration bytes for ATtiny26.
Submitter: | Anatoly Sokolov <aesok> | ||
Submitted: | Thu 10 Mar 2005 11:42:12 AM UTC | ||
Category: | None | Priority: | 5 - Normal |
Status: | None | Privacy: | Public |
Assigned to: | None | Open/Closed: | Open |
Sun 13 Mar 2005 01:05:41 PM UTC, comment #1: |
Anonymous |
Thu 10 Mar 2005 11:42:12 AM UTC, original submission:
Implement reading up to 4 calibration bytes for ATtiny26 as request in support item # 103567. It was testeg using Altera ByteBlasterMV Parallel Port Download Cable. Should working with other hardware also. |
Anatoly Sokolov <aesok> |
Attached Files
Depends on the following items: None found
Items that depend on this one: None found
CC list is empty
There are 0 votes so far. Votes easily highlight which items people would like to see resolved in priority, independently of the priority of the item set by tracker managers.
Follows 1 latest change.
Date | Changed by | Updated Field | Previous Value | => | Replaced by |
---|---|---|---|---|---|
2005-03-10 | aesok | Attached File | - | Added patch.diff, #4321 |
Powered by Savane 3.13-02a9.
Corresponding source code
Looks good with an STK500 under OSX 10.3.5:
jfiresto% ./uisp -v -dserial=/dev/tty.modem -dpart=attiny26 -dprog=stk500 --rd_cal=4
Firmware Version: 1.10
Atmel AVR ATtiny26 is found.
Firmware Version: 1.10
Calibration Byte 0 = 0x96
Calibration Byte 1 = 0x97
Calibration Byte 2 = 0x8d
Calibration Byte 3 = 0x91
Thanks!
John Firestone